How To Connect A Washing Machine To A Drain Pipe That Is Below Grade

1

Locate the washer box. This small box, which fits in between the wall studs behind the washing machine, contains the water supply valves for the washer and a short pipe that sticks out the bottom, called a stub-out.

2

Figure the shortest and simplest route between the below-grade drainpipe as well as the stud wall nearest the washing machine. All home configurations are different, but drainpipes run horizontally in between floor joists or they drop vertically in between wall studs.

3

Connect a 2-inch PVC P-trap to the bottom in the stub-out on the washer box. Anytime you connect any fittings, use PVC cleaner and PVC glue in accordance with every single product’s instructions. Use a utility knife to cut out a section of drywallHow to Connect a Washing Machine to a Drain Pipe That Is Below Grade, extending from the center the stud on a single side in the washer box for the center with the stud on the other side. Just after plumbing the washer drain, replace the drywall section and tape Fix Washing Machine Problems the seams.

4

Install a 2-inch PVC T-fitting on the horizontal end from the P-trap. This should be within the stud wall right behind the washing machine.There are three openings on a T-fitting. A single connects to the horizontal pipe, one faces straight down, and the other faces straight up.

5

Connect 2-inch PVC pipes to both the upper as well as the lower opening within the T-fitting. The upper pipe runs {Click Here|Read More|Visit Site|View Site|more info|homepage here} up by way of the stud wall, till reaches the atticHow to Connect a Washing Machine to a Drain Pipe That Is Below Grade, where you will connect it to the home’s main vent stack. The lower opening connects to a PVC drainpipe that runs down towards the drain line. When a floor or ceiling plate is within the way, use a drill, fitted having a 2 1/2-inch hole bit, to make a hole substantial enough to run the pipe through.

6

Measure the distance from end to end of a 4-by-2 PVC sanitary reducer T-fitting. Subtract the distance in the “lips” on both sides. For example, if the sanitary T-fitting is 12 inches long from end to end, but the lips, which are the rims on each and every end where the pipe will fit, are every two inches deep, subtract 4 inches from 12 inches, leaving 8 inches. This will be the cutting measurement.

7

Cut the main drainpipe using a reciprocating saw to coincide together with the measurement. Most main drainpipes are 4 inches in diameter and made from PVC.

8

Position the sanitary T-fitting over both ends of the cut drainpipe with the top rated, 2-inch connection facing upward. Use PVC cleaner and glue to attach the fitting.

9

Connect the bottom in the 2-inch PVC washing machine drainpipe towards the 2-inch opening of the sanitary T-fitting.

How To Connect A Washing Machine To A Drain Pipe That Is Below Grade

How To Drain A Washing Machine Manually