Samsung Washing Machine Errors

SF #

In a Samsung washerSamsung Washing Machine Errors, an "SF #" error indicates a system error. These types of errors cannot be cleared manually. Instead, a service technician must be contacted to examine the machine.

2E

A "2E" error occurs when a Samsung washer detects a high or low voltage issue. In many cases, restarting the cycle clears the error. However, if the error code appears again, call an authorized service technician.

3E

A "3E" error in a Samsung washer indicates that there is an issue with all the motor. Restarting the cycle might clear the error, but a service technician should be consulted if the error code appears again.

7E

When a "7E" error occurs, there is a problem with silver ions in a Samsung washer. The washers utilize two pure silver plates that serve as electrodes for the water inlet system. During Clear Away Washing Machine Smells the wash and final rinse cycles, silver ions are sprayed into the tub. The "7E" code might possibly indicate that there is an excess of ions inside the washer. This error cannot be cleared manually. An authorized service technician must be consulted to address the problem.

E3

The "E3" error indicates that a Samsung washer's motor Fix Washing Machine Problems is not running properly. The cycle can usually be restarted by pressing the "Start/Pause" button. However, when the error code appears again, you should contact an authorized service technician.

SUdS

In a Samsung washer, the "SUdS" error indicates that excessive suds have been detected during a washing cycle. As a result, the machine stops its normal cycle and begins a suds reduction process. When the suds have been sufficiently reduced, the washer will operate as normal. In most cases, excessive suds appear in the washer because too much detergent has been used.

LE

The "LE" error occurs when a Samsung washer is within the process of filling but cannot reach the required water level. In most cases, there is an issue using the washer's water inlet hoses. Check that they are installed properly and there are no kinks in the hoses. If there are no obvious problems with all the inlet hoses, contact an authorized service technician to address the problem.

nd

An "nd" error occurs when your Samsung washer is unable to drain. This error code could also appear when the washer senses a clog while in the process of draining. Clean the washer's filter to see when the clog is preventing the water from draining properly. Turn the washer offer approximately ten seconds and turn it back on againSamsung Washing Machine Errors. Start a spin cycle only and press the "Start/Pause" button to start the water draining. If the water still does not drain, call an authorized service technician.

nF

The "nF" error indicates that a Samsung washer has attempted to fill but is unable to do so. Check that your washer's water supply valves are opened, and examine the water inlet hoses for any kinks that might prevent water from reaching the appliance. Examine the fill hoses' inlet screens to be certain that they are not clogged as well.

dc

A "dc" error occurs when a Samsung washer is unable to spin due to an unbalanced load. Redistributing the items inside the washer and pressing the "Start/Pause" button typically clears this error.

Samsung Washing Machine Errors